I went through another round of marking areas where the fit needed to be adjusted before removing the cabin top again. I needed to remove quite a bit more from the sill area. I also needed to remove some of the aft edge.
It fits much better after the adjustments but I still think I might need to remove more from the sill area. I also haven’t dealt with the intersection with the upper forward skin yet.
![](https://airplane.allanglen.com/wp-content/uploads/2022/06/pxl_20220605_0319219251845981258140387128.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2022/06/pxl_20220607_0158287024279417866032752993.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2022/06/pxl_20220607_0204439327400263936709451119.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2022/06/pxl_20220607_0205348441735227994932414406.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2022/06/pxl_20220607_0416045125182449068895217269.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2022/06/pxl_20220607_0416434778496042451082962465.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2022/06/pxl_20220607_0416513951502655699744142224.jpg)