I plan on finishing and painting the A-pillars when I take the cabin top off to mount the overhead console.
I test fit the Aerosport glareshield cover with the Aerosport side panels to determine how these parts would fit together.
I trimmed the side panels to fit against the glareshield cover and the A-pillars. I have some gaps to fill so I used a small amount of micro up to the side panels. I’ll use this edge as a guide when finishing the rest of the pillars.
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240209_0341094725834491724369829631.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240210_013912778914708705866838521.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240209_0250518386034593943600899528.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240210_0259519656798724666935726962.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240210_0259396211071139011537498774.jpg)
I was able to slide the side panels underneath the corners of the Aerosport panel which provides a clean edge.
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240210_0138460611729538293169467970.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240210_0138511172668235017483725085.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240210_0138594892779830984362321186.jpg)