I’ll be removing the cabin top to permanently attach the overhead console and finish the interior of the cabin top.
Prior to that, I wanted to pre-fit the fiberglass from the Aerosport headliner kit. This will give me a better idea of the edge up to where I need to finish the cabin top.
I aligned the fiberglass on the outside of the cabin top to do the initial trimming, then slowly trimmed the fiberglass while inside the airplane (leaving about an 1/8″ around the edges). The lower edge will be covered by the Aerosport side panels.
Other than being repetitive (fit, mark, trim, repeat) this task was pretty easy to do. I’ll install the headliner material when the cabin top is permanently installed.
