I’ll be removing the cabin top to permanently attach the overhead console and finish the interior of the cabin top.
Prior to that, I wanted to pre-fit the fiberglass from the Aerosport headliner kit. This will give me a better idea of the edge up to where I need to finish the cabin top.
I aligned the fiberglass on the outside of the cabin top to do the initial trimming, then slowly trimmed the fiberglass while inside the airplane (leaving about an 1/8″ around the edges). The lower edge will be covered by the Aerosport side panels.
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240211_0310418425524167628268286538.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240211_0310475885933842161433050187.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240211_031052403496697955006745386.jpg)
Other than being repetitive (fit, mark, trim, repeat) this task was pretty easy to do. I’ll install the headliner material when the cabin top is permanently installed.
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240211_044440910353847964513838582.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240211_0141242275432434804498605572.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240211_0141288625542678752153031669.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240211_0141381963845319857788132695.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240211_0141416774173633978638136993.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240211_0141447293687588123723125413.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240211_0254474872061143061654143385.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240211_025502838931067725640315803.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2024/02/pxl_20240211_0255101805390552941714805626.jpg)