I have been been working on side skin riveting in the past several work sessions. This step starts at the seam between the side skins.
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211209_0124528628751983590731232404.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/PXL_20211209_044847610.MP_-scaled.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/PXL_20211209_044831818-scaled.jpg)
I then proceeded with the riveting of the left mid skin to the understructure.
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211209_0125038509057697318579645944.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211209_0446034934795833387016087994.jpg)
Then on to the right mid skin. There are some tricky rivets but everything went well. I have a few rivets under the temporary wing attach bolts that I’ll tackle later once the gear mounts are partially bolted into place.
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211211_0423121147897433272459368129.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211211_0423288103254442381993067447.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211211_0423416299051242604459139546.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211211_0423533523543750188532052262.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211211_0424056296582547773630217824.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211211_0424172342509030213760116238.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211211_0425267533483004507097970009.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211211_0425329403808283232892206320.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211211_0425389054557656738734865910.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/12/pxl_20211211_043915407261215150933129851.jpg)
I’ll need some help riveting along the curve at the lower edge of the skins but these skins are otherwise complete!