I completed the small task of installing the extensions for the flap actuator. This is easier to do now before the bottom skins are riveted into place.
I riveted the nutplates to the extensions with the pneumatic squeezer.
![](https://airplane.allanglen.com/wp-content/uploads/2021/06/pxl_20210628_1329198754531435659999761014.jpg)
I then riveted the left bracket into place.
![](https://airplane.allanglen.com/wp-content/uploads/2021/06/pxl_20210628_1409457562045346470993707196.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/06/pxl_20210628_1410438525309379583012963569.jpg)
I then installed the AN hardware.
![](https://airplane.allanglen.com/wp-content/uploads/2021/06/pxl_20210628_1422362642988101215096835557.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/06/pxl_20210628_1823563366204358265722456913.jpg)
![](https://airplane.allanglen.com/wp-content/uploads/2021/06/pxl_20210628_1824185706441941620177040021.jpg)
The rest is easy to access so I’ll install that later when I install the actuator.